4 - 59
ENG
ENGINE ASSEMBLY AND ADJUSTMENT
11.Install:
● Washer 1
● Clutch housing 2 (primary)
● Washer 3
● Clutch carrier assembly 4
NOTE:
● The secondary clutch housing has two
grooves 1 machined into it permit the
primary drive gear behind the primary
clutch to clear the secondary clutch.
● Align one of these grooves with the pri-
mary gear 2 before installing the primary
clutch housing.
12.Install:
● Lock washer 1
● Nut 2 (primary clutch)
WARNING
Always use a new lock washer.
NOTE:
Make sure that the tabs of the lock washer
engages the indentations in the clutch car-
rier.
13.Tighten:
● Nut 1 (primary clutch)
NOTE:
Hold the clutch carrier 2 by the Rotor
Holder 3 to tighten the nut.
14.Bend the lock washer tab 4.
T
R
.
.
Nut (primary clutch):
78 Nm (7.8 m • kg, 56 ft • lb)
Rotor holder:
P/N. YU-01235, 90890-01235
4
