Parameter Settings
TENORI-ON Manual 69
Setting Parameters with the Jog Dial ■ File Menu
6 When the All Blocks file has been loaded the display shown in step 2, above, will
appear, and playback of the All Blocks file will begin.
Press the [OK] button in the status display when you want to stop playback.
● Save All Blocks
Saves an All Blocks file containing all active notes and settings such as voice, tempo, etc.,
for all layers and blocks to an SD Memory Card.
1 Insert an SD Memory Card that has sufficient free space for the file to be saved into the
TENORI-ON card slot.
2 Use the jog dial and [OK] button to navigate to the All Blocks function menu as follows:
"Main menu" ➝ "File menu" ➝ "All Blocks"
3 Use the jog dial to highlight the "Save" function, then press the [OK] button.
The file name entry display will appear. A default file name will be provided, which you
can either use as-is or replace with a name of your own.
File name entry procedure is described in the Rename Song section on Page 65.
4 When the file name has been entered as required use the jog dial to highlight the "
§
"
symbol in the lower right corner of the display and press the [OK] button.
The file name will be entered and the save function will be executed.
A display like the one shown below will appear while the All Blocks file is being saved.
You can cancel the operation by pressing the [OK] or [CANCEL] button.
File data may be irreparably corrupted if you turn off the power or remove the SD Memory Card while the
"Saving…" display is showing.
All Blocks ∞
Operation: Load
All Blocks ∞
Operation: Save
Input File Name ∞
[0302E-BLOCKS-02 ]
ABCDEFGHIJKLMNOPQRST
UVWXYZ-0123456789 ª§
Current All Blocks File Name
Available Characters
Input Cursor
Set File Name
Backspace & Delete 1 Character
Blocks: ∞
"1-BLOCKS1020-01 "
Saving... CANCEL
The name of the All Blocks file being
saved.
