Filter
Top Products
18
• CC (Continuous Controller): Biting the mouthpiece will send a MIDI Continuous
Controller (CC) message. If you select this, press the Trans Button to set additional
message parameters:
o En (Enable): This determines whether CC output is enabled or disabled. If you
select this, press and hold the Trans Button, and press the Hold Button or
Interval Button to turn it on (On) or off (OF). When it is on, a dot will appear in
the display.
o Cn (Controller Number): This is the CC number that will be sent when you bite
the mouthpiece. Use the Hold Button or Interval Button to set the CC number
(01–127; values over 99 will be shown as the last two digits with a dot between
them). Match this number to the CC number of the parameter you want to
control.
Important: We recommend setting En to off (OF) before changing this
parameter to prevent accidentally muting the EWI5000's output while moving
through CC #7 (Volume).
o nb (Not Biting): The value that will be sent with the CC message when you are
not biting the mouthpiece. Use the Hold Button or Interval Button to set the
value (00–127; values over 99 will be shown as the last two digits with a dot
between them).
o bt (Biting): The value that will be sent with the CC message when you are
biting the mouthpiece. Use the Hold Button or Interval Button to set the value
(00–127; values over 99 will be shown as the last two digits with a dot between
them).
4. To return to Performance Mode, press the Setup Button until the display is blank.