Filter
Top Products
28
• CC (Continuous Controller): The Hold Button will send a MIDI Continuous
Controller (CC) message. If you select this, press the Trans Button to set additional
message parameters:
o Cn (Controller Number): This is the CC number that will be sent when you
press the Hold Button. Use the Hold Button or Interval Button to set the CC
number (01–127; values over 99 will be shown as the last two digits with a dot
between them). Match this number to the CC number of the parameter you
want to control.
o dU (Data-Up): The value that will be sent with the CC message when you
release the Hold Button. Use the Hold Button or Interval Button to set the
value (00–127; values over 99 will be shown as the last two digits with a dot
between them).
o dP (Data-Press): The value that will be sent with the CC message when you
press the Hold Button. Use the Hold Button or Interval Button to set the
value (00–127; values over 99 will be shown as the last two digits with a dot
between them).
o LA (Latching): This determines if the Hold Button acts as a latching control or
momentary control. If you select this, press and hold the Trans Button to set
additional message parameters:
OF (Off): When you press and hold the Hold Button, the Data-Press value
will be sent. When you release the Hold Button, the Data-Up value will be
sent.
on (On): When you press the Hold Button
, the Data-Press value will be
sent. When you press the Hold Button again, the Data-Up value will be
sent.
4. To return to Performance Mode, press the Setup Button until the display is blank.