Filter
Top Products
XP-3™ Fuse & Lamp Replacement
with halogen lamps.
Never touch the new lamp with your bare
fingers.
2.
Remove the thumb screw on the rear of the unit’s head. This screw
hold the lamp socket cover in place.
3.
Pull back the cover once the screw has been removed to access
the socket assembly.
4.
Carefully remove the old lamp and discard it in the trash.
5.
Replace the lamp with an exact match and reassemble.
©
American DJ
®
- www.americandj.com - XP-3™ Instruction Manual Page 19
©
American DJ
®
- www.americandj.com - XP-3™ Instruction Manual Page 20
XP-3™ Fuse & Lamp Replacement
Caution:
Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American
DJ
®
DJ®DJ
technician.
® technician. ®
Replace with anything other than the specified part can damage your
unit and will void your manufactures warranty.
Warning:
If, after replacing the lamp or fuse either one continues
to blow, STOP using the unit. Contact customer support for further
instructions, you may have to return the unit for servicing. Continuing
to use the unit may cause serious damage.
Fuse Replacement:
Disconnect the unit’s main power supply.
Insert a standard flat head screw driver in to the fuse holder
housing. Turn the screwdriver in counter-clockwise direction to
remove the fuse holder. Remove the fuse holder to expose
the fuse. Remove the old fuse and discard it. Replace the fuse
with the same type. Insert the fuse holder back into it’s housing
and turn it in clockwise direction to lock the holder in place.
Lamp Replacement:
Caution! Never attempt to change the lamp
while the fixture is plugged in. Always disconnect the main power and
allow the unit ample time to cool before attempting to replace the
lamp. Lamp replacement has been made simple by incorporating the
use of a flip-up front cover that is retained by thumb screws.
1.
Be sure to follow the proper handling procedures that deal
Thumb Screw
Lamp Cover
Lamp Socket
Assembly
XP-3™ Halogen Lamp Warning
This fixture is fitted with halogen lamps which
are highly susceptible to damage if improperly
handled. Never touch the lamps with your
bare fingers as the oil from your hands will
shorten lamp life. Also, never move the fixture
until the lamps have had ample time to cool.
Remember, lamps are not covered under war-
ranty conditions.