Filter
Top Products
©
American DJ
®
- www.americandj.com - XP-3™ Instruction Manual Page 10
©
American DJ
®
- www.americandj.com - XP-3™ Instruction Manual Page 9
XP-3™ Controls and Functions
13
11
7
9
10
6
5
1
1
TOP
BOTTOM
12
4
3
2
8
1.
Lens -
This is a fully focusing high quality lens. Focus the lens by manually
turning the lens in a clockwise or counter-clockwise direction until the
image is in focus.
2.
XLR Output Jack -
This jack is used to transmit the incoming DMX signal to another DMX
xture, or transmit a Master/Slave signal to the nest XP-3™ in the
chain. For best results in DMX or Master/Slave mode, terminate this
jack if it is the last unit in the chain. See
“Terminator”
on page 7.
“Terminator” on page 7. “Terminator”
3.
XLR Input Jack -
This jack is used to accept an incoming DMX signal (from a universal
DMX controller) or Master/Slave (from the output jack of another
XP-3™) signal.
4.
MINI/C Controller Jack
-
This jack is for use with the optional
MINI/C Blackout controller only.
See page 7 for details on the MINI/C controller.
Do not attempt to con-
nect an audio signal this jack, this will damage the PC board and void
your manufactures warranty!
5.
Power Cord Connection -
The power connection uses an I.E.C. type connector, use only a power
cord that matches this type of connection. Be sure to only connect
this unit to a power outlet that matches the printed power label on the
unit. Never use a power when the ground prong has been removed or
broken off. The ground prong is used to reduce the risk of electrical
shock in case of an electrical short. .
6.
Fuse Holder -
This housing stores the 5 amp GMA protective fuse. Always
replace with the exact same type fuse, unless other
wise instructed, by
an authorized American DJ
®
service technician.
7.
Lamp Socket Cover Thumb Screw -
This thumb screw holds the lamp socket assembly cover (16) into
place.
8.
Lamp Socket Cover -
This thumb screw holds the lamp socket cover (16) into place.
XP-3™ Controls and Functions