Filter
Top Products
Section 4
Software Setup
Setup 4‐1
Overview
Programming setup is accomplished using the keypad of the control.
General programming steps are defined in the appropriate control
manual.
To install the expansion board see Section 3 of this manual.
1. Install EXBHH005 expansion board. If the board is in Slot 1, the
OP1 inputs and outputs are used. If the board is in Slot 2, the
OP2 inputs and outputs are used.
2. Set the Level 1 Input Setup block Command Source (P#1402) to
select the desired analog input to use.
3. Refer to Figure 4‐1 and the Optional Analog Parameter tables and
set the parameter values as desired for each input or output used.
Figure 4‐1 Relationship of Parameters
5
4
3
2
9
8OPT DAC1
OPT DAC2
ANA In1+
ANA In1-
ANA In2+
ANA In2-
EXBHH005 HI RES Expansion Board
Type
Type
Gain Invert Offset
Gain Invert Offset
To Control Bd.
Type
GainInvertOffset
Type
GainInvertOffset
To Control Bd.
From Control Bd.
From Control Bd.