Filter
Top Products
4‐2 Setup
Hi RES Parameters
Level 1, Input Setup Block
Parameter
P# Adjustable Range Factory User Setting
COMMAND
SOURCE
1402 3-KEYPAD
4-NETWORK
5- Opt1 Ana In1
6- Opt1 Ana In2
7- Opt2 Ana In1
8- Opt2 Ana In2
9-EXB PULSE FOLL
1
OP1 ANA IN1
TYPE
1451 0-None, 1-(-10V to+10V),
2-(-5V to+5V),
3-(4to20mA), 4-(0to20mA)
1
OP1 ANA IN1
Invert
1452 0-OFF, 1-ON 0
OP1 ANA IN1
Gain
1453 0.0% TO 300.0% 100.0
OP1 ANA IN1
Offset
1454 -100.0% TO 100.0% 0.0
OP1 ANA IN1
Deadband
1455 0.0% TO 75.0% 0.0
OP1 ANA IN1
Filter
1456 0 (No Filter) TO 6 (Max Filter) 0
OP1 ANA IN2
TYPE
1457 0-None, 1-(-10V to+10V),
2-(-5V to+5V),
3-(4to20mA), 4-(0to20mA)
1
OP1 ANA IN2
Invert
1458 0-OFF, 1-ON 0
OP1 ANA IN2
Gain
1459 0.0% TO 300.0% 100.0
OP1 ANA IN2
Offset
1460 -100.0% TO 100.0% 0.0
OP1 ANA IN1
Deadband
1461 0.0% TO 75.0% 0.0
OP1 ANA IN1
Filter
1462 0 (No Filter) TO 6 (Max Filter) 0
OP1 parameter selections (P#1451 to 1462) are available if the
expansion board is installed in Slot1 of the Control.