Filter
Top Products
English
Recording Your Keyboard Play
E-47
8.
Press
8
twice to exit the recorder mode.
• The flashing on the screen shown in step 3 becomes
faster when remaining recorder memory capacity
becomes less than 100 notes.
• Total recorder memory capacity is approximately
12,000 notes. Recording will stop automatically when
there is no more unused recorder memory remaining.
• Each press of
8
cycles through the settings shown
below. You can listen to the recorded data as many
times as you like by pressing
bo
while in playback
standby.
■To delete recorded data
After step 3 of the above procedure, do hold down
8
(without
pressing any keyboard key) until the message “Tr.Del?”
appears on the display. Press [+] (YES) to delete the data, or
[–] (NO) to cancel the delete operation.
• Turning off the piano while recording is in progress will
cause any data in recorder memory to be deleted.
• A new recording replaces (deletes) previously recorded
contents.
■Maintaining Data in Recorder Memory
After you save data in recorder memory, it will remain there as
long as power is supplied to the piano. However, if you
disconnect the AC adaptor, data in recorder memory will be
deleted.
You can divide a song according to various types of parts
(instrument, left and right hand, etc.), and record each part to
a specific track. You can mix up to six tracks (the original track
plus five additional tracks) into a final song.
■About tracks
Tracks are numbered from 1 to 6.
• If you do not specify a track number when recording,
recording is performed to Track 1 automatically.
In addition to what you play on the keyboard, the following
information also is recorded.
• Track 1
Settings:
Tone number, rhythm number, tempo, reverb, chorus,
chords, layer/split settings, Auto Harmonize/Arpeggiator
setting
Operations:
Pedal, pitch bend wheel, INTRO button, SYNCHRO/
ENDING button, NORMAL/FILL-IN button, VARIATION/
FILL-IN button
• Tracks 2 through 6
Tone number, pedal operation, pitch bend wheel operation
1.
Record the first part to Track 1.
To record to Track 1, perform steps 1 through 4 under
“Recording and Playing Back Keyboard Play” (page
E-46).
2.
Press
8
.
This will enter record standby.
Disappears
Recorder Off
Playback
Standby
Record
Standby
Disappears Lights Flashes
Using Tracks to Record and Mix
Parts
To record to Tracks 1 through 6
Lights
Lights
Flashes
Flashes
C