Filter
Top Products
English
Selecting and Playing a Tone
E-15
To use layer and split together
1.
Use the
“Tone List” (page E-57)
to look up the
group(s) and numbers of the tones (UPPER 1,
UPPER 2, LOWER 1, and LOWER 2 zone
tones) you want to use.
2.
Check to make sure that the both the
(LAYER) and
(SPLIT) button lamps are
unlit.
• If one or both lamps are lit, press the
(LAYER) and
(SPLIT) buttons to turn them off.
3.
Press the
(UPPER 1) button so its lamp is
lit.
• This indicates you can select the UPPER 1 zone tone.
4.
Select the UPPER 1 zone tone.
• For details about selecting tones, see “To select a
tone” (page E-11).
5.
Press the
(LAYER) button so its lamp is lit.
• This will cause the
(UPPER 2) button lamp to
light. This indicates you can select the UPPER 2 zone
tone.
6.
Select the UPPER 2 zone tone.
7.
Press the
(LAYER) button so its lamp is
unlit.
8.
Press the
(SPLIT) button so its lamp is lit.
• This will cause the
(LOWER 1) button lamp to
light. This indicates you can select the LOWER 1 zone
tone.
9.
Select the LOWER 1 zone tone.
10.
Press the
(LAYER) button so its lamp is lit.
• This will cause the
(LOWER 2) button lamp to
light. This indicates you can select the LOWER 2 zone
tone.
11.
Select the LOWER 2 zone tone.
12.
Play something on the left and right sides of
the keyboard to confirm that the tones are
assigned and layered properly.
• You can change any of the zone tones at any time by
performing one of the operations shown below.
LOWER 1 UPPER 1
LOWER 2 UPPER 2
Lit
Lit
Lit
Unlit
To change this
zone’s tone:
Do this:
UPPER 1 zone Press the
(UPPER 1) button and
then select a tone.
UPPER 2 zone Press the
(UPPER 2) button and
then select a tone.
LOWER 1 zone Press the
(LOWER 1) button and
then select a tone.
LOWER 2 zone Press the
(LOWER 2) button and
then select a tone.
Lit
Lit
Lit
Lit