Casio PX-3 Electronic Keyboard User Manual


 
E-16
Selecting and Playing a Tone
13.
To cancel layer and split, press

(LAYER)
and

(SPLIT) buttons again so their lamps
go out.
NOTE
When using Layer and Split at the same time, you
can switch to only a single tone in either of the
keyboard ranges by configuring INT OFF for the
zone whose tone you do not want to sound. For
example, you could perform the steps below to
sound zones UPPER 1, UPPER 2, and LOWER 1,
without sounding the LOWER 2 zone.
Pressing the
(UPPER 1),
(UPPER 2),
(LOWER 1) or
(LOWER 2) button causes the
lamp of the pressed button to light, and the lamps of
the other buttons to go out. At this time, the tone
name of the zone whose button you press will
appear on the display, and you can change the tone,
if you want. However, the tones that sound when a
keyboard keys are pressed depend on the current
Layer and Split on/off settings.
The
(INT/EXT) button is for specifying what each
zone controls (INT = internal sound source, EXT =
external MIDI device). The INT (left) side lamp
indicates internal sound source control on/off, while
the EXT (right) side indicates external MIDI device
control on/off. For details about this button, see
“Using the Digital Piano as a MIDI Master
Keyboard” (page E-26).
1. Press the
(LOWER 2) button so its lamp is lit.
2. Press the
(INT/EXT) button twice so the INT
side (left side) lamp goes out.
LOWER 1
UPPER 1
UPPER 2
Lit
Unlit