Filter
Top Products
E-87
Saving Data
CURSOR
DISK/CARD
●WK-3800
●WK-3300/WK-8000
CARDSD memory card slot
●WK-3300/WK-3800 ●WK-8000
Eject button
[+]
/
[–]
YES/NO
Inserting and Ejecting a Diskette
The following describes how to insert a diskette into the disk
drive and how to eject it.
To insert a diskette into the floppy disk drive
1
With the label area of the diskette facing up, insert
the diskette shutter first into the disk drive, as shown
in the illustration.
2
Slide the diskette into the drive as far as it will go,
until it clicks into place.
To eject a diskette from the floppy disk drive
IMPORTANT!
• Before ejecting a diskette, always check to make sure
that the access lamp is not lit or flashing. A lit or flashing
access lamp means that the keyboard is performing a
data read or write operation. Ejecting a diskette while it
is being accessed can cause its data to become
corrupted.
1
Press the Eject button.
• This causes the diskette to be partially ejected from
the disk drive.
2
Remove the diskette from the drive by hand.
Using External Storage Media
This section explains how to use SD memory cards and floppy
diskettes (WK-3800 only) for data storage. In this manual,
SD memory cards and floppy diskettes are collectively
referred to as “external storage media”.
NOTE
• Layer, split, and Auto Harmonize are automatically turned
off while external storage is being used. Tone and rhythm
selection, and rhythm playback are also all disabled.
Basic Memory Card Operation
1
Insert the memory card into the card slot.
2
Enter the Card Mode.
* WK-3800
Press the DISK/CARD button twice.
• This causes the DISK/CARD indicator to appear on
the display, and also displays “Card” in the display’s
text area.
* WK-3300/WK-8000
Press the CARD button.
• This causes the CARD indicator to appear on the
display, and also displays “Card” in the display’s text
area.
NOTE
• After pressing the DISK/CARD button (WK-3300/WK-
8000: CARD button) once, you can use the [̇] and [̈]
CURSOR buttons to select the external storage media.
3
Press the [̄] CURSOR button to display the Card
Mode menu.