Filter
Top Products
Chapter 3 Hardware Installation
9
3. Connect the power cord to the power socket on the rear panel of
Compex SGX3226.
NOTE
For proper ventilation, do allow about at least 4 inches of clearance on the
front and 4 inches on the back of the Switch. This is especially important for
enclosed rack installation.
3.1.3 Expansion Module Installation
A series of optional expansion modules are available for Compex SGX3226
to enhance the features. As Compex SGX3226 supports the hot plug
function, you may install or uninstall the modules without turning off the
switch.
1. Please note that Compex SGX3226 is shipped with the Gigabit
modules.
2. Insert the module carefully into the expansion module window and
push it along the module rail until it stops. Ensure that there is a secure
connection to the PCB Board of Compex SGX3226.
3. The Ready LED of the related port will lights up.
4. Tighten the screws on the module.
3.1.4 To remove Expansion Module
1. Disconnect any cable from the module.
2. Unscrew and pull out the module slowly from the expansion module
slot.
3. Slide the module completely out of the chassis and cover the window
with the cover plate, screwing back using the original screws.