Filter
Top Products
Basic Operations
Xboard 37
Tips for Use…
Assuming you wish to use the “CC Send On Recall” feature with a particular patch,
turn this option on while editing the controller initial value settings in that patch.
Once you’ve stored the patch with the desired initial controller settings, switch this
option oFF and store the patch one more time. This will save the oFF setting for
this option in the patch. Since the on/oFF setting will also be recalled whenever
you recall the patch, the oFF setting ensures that the initial controller settings
won’t be accidentally overwritten if you later change some other setting in the
patch and store it again. If you later want to change one or more of these settings,
simply switch the setting back on before storing the patch with the updated
settings (and don’t forget afterwards to switch the option back oFF and store the
patch again as described above, to lock in the updated settings).
Aftertouch On/Off
When Aftertouch is On, the keyboard will transmit channel aftertouch messages.
Aftertouch is transmitted when additional pressure is applied to the keyboard after
the keys have been pressed.
Select on to turn Aftertouch on, or oFF to turn it off.
Note: This setting, unlike most of the settings described in this section, is a device
setting, which is not stored in or recalled from patches. It is thus also a global
setting which affects all patches in common – or rather, it affects device behavior
independently of patches.
Semitone Transpose
The keyboard can be transposed up or down in one-semitone steps. Transpose
works by shifting the keyboard position relative to middle C.
The transposition range is -64 to +63 semitones.
Note: Semitone Transpose is disabled when Zones are enabled.
X Board.book Page 37 Wednesday, April 12, 2006 10:44 AM