Filter
Top Products
Basic Operations
E-MU Systems 40
Pedal (PEd)
This function sets up the Footswitch / Footpedal input to accept a switch or a
variable pedal control input.
• SuS = Sustain or footswitch input. In this mode, the Xboard automatically
senses the footswitch polarity on power up (either normally-open, or
normally-closed). Because of the automatic sensing feature, you should not
hold down the footswitch during power up or the switch action will be
reversed.
• ctL = Control Pedal. The Xboard accepts control pedals wired as shown on
page 65.
Indicators (ind)
The decimal points in the LED indicate USB and MIDI activity. Select on or oFF.
1st = USB In; 2nd = USB Out; 3rd = MIDI Out.
Zones On/Off Status Display (Zod)
Select on or oFF.
If on, when you select a new patch, the Edit LED display shows a message
indicating whether zones enabled or disabled in the new patch. This is especially
useful for the Xboard 25 and Xboard 49, since they don’t have a Zones Enable
button.
Patch Buttons Program Change Mode Auto-Disable (PbM)
Select on or oFF.
With this setting on, the Program Change Mode button turns off automatically
after you send a program change, returning the numeric keypad to Direct Patch
Select Mode.
With this setting off, the Numeric Keypad remains in Program Change mode after
you send a program change.
Calibrate Sub-Menu (CAL)
When you select CAL and press Enter, you are taken to the CAL sub-menu, which
contains calibration functions. To select a function, use the data slider to select a
Calibration function, and press Enter. To cancel, press Home.
CCM
This feature enables you to calibrate any control on your Xboard, one at a time,
optimizing your Xboard’s action for your playing technique.
After you select the CCM function and press Enter, all LEDs on the Xboard turn off
(except the display, which says “adjust a control”). This is Calibration Standby
mode. What you do next depends on which control you want to calibrate.
X Board.book Page 40 Wednesday, April 12, 2006 10:44 AM