Filter
Top Products
– 8 – ETAsys.com
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800-321-6699 • Fax: 800-996-3821
4. Channel Selection Switches – These push button switches allow the selection of the channel to be viewed at the Voltage and
Current Meter.
5. Channel Selected LEDs – There are six Channels in the ETA-ECS6RM and only one Channel Voltage or Current can be viewed at a
time. The Channel selected and being viewed is indicated by the illuminated LEDs.
6. AC Mains Voltage and Current Meter – There is only one Volt and Current
Meter. There are up to six Channels of viewing required and the channel must
be selected to monitor. The Channel you are viewing will have a single LED
illuminated. Refer to the Channel Select LED. The Voltmeter has a 2% accuracy
tolerance and will indicate the Voltage present at an ECM module. For the
Current reading to function an ETA-ECM20M, ETA-15SH or an ETA-20SH module
must be connected. Also a minimum of 500mA of current draw must be at the
ECM module for the ETA-ECS6RM to read. Less than that the display will read
”nA”. When using the ETA-ECM20 module the Current display will read "nA"
because it has no current sensing circuitry.
Note: When first applying power to the ETA-ECS6RM and no ECM modules are connected the Voltage display will display "nC"
because it has no external voltage to read.
7. Light Socket – The XLR socket is used for the optional 12VDC AP-GNL18 LED Gooseneck Lamp. One lamp, from ETA Systems
sister company Atlas Power, is included. Additional lamps are available through ETA.
Note: This is not an audio connection.
8. Light On/Off Switch – This switch turns On or Off the voltage to the XLR lamp socket.
9. Adjustable and Removable Rack Mount Ears – The depth of the ETA-ECS6RM can be adjusted to meet the requirements of the
rack. Loosen the corresponding screws, set depth and retighten screws. The rack ears can also be removed.
ETA-ECS6RM
Electrical Control Sequencer
9 7 8 4 6 95