Filter
Top Products
professional control surface
Artist Series
USER GUIDESETUP AND INSTALLATION
17
5. Plug one end of the Ethernet crossover cable into the Ethernet jack (labeled
with ) on the rear panel of the MC Mix (Figure 2-8).
Figure 2-8 Ethernet cable and rear panel jack
6. Plug the other end of the Ethernet crossover cable into an open Ethernet
jack on your computer, router, or Ethernet switch (Figure 2-9).
An Ethernet router or switch is required to connect additional MC Mix units
or to a local area network. Note that connecting directly to the computer
(Figure 2-9-right) may require removing your Internet cable.
Figure 2-9 MC Mix connected to router (left) and directly to computer (right)
7. Turn on your router (if applicable), then turn on your Mac and wait until it
finishes starting up.
Eucon
Ethernet
cable