Fostex FM-3 DJ Equipment User Manual


  Open as PDF
of 27
 
(1) Press the [ ] key long enough to enter the
display brightness adjustment mode.
The brightness adjustment bar appears, showing the
current brightness level.
<Note>:
If you do not press any key for approximate-
lyvesecondswhilethebrightnessadjustmentbaris
shown, the bar automatically disappears and the unit
exits the display brightness adjustment mode.
Adjusting the display brightness
(3) By pressing the [EDIT] key immediately after
adjusting the brightness level, the brightness
adjustment bar disappears and the unit exits the
display brightness adjustment mode.
The display on the front panel of the unit normally
shows the VU and peak meters. You can select stereo
or mono metering. The display also can show the status
of inputs, outputs, etc., which you can edit. You can also
adjust the display brightness to match the circumstance.
For display-related operation, the following three keys
are used.
You can set the display brightness to match the circum-
stance (by default, it is set to level 3).
The display brightness setting remains even after you
turnofftheunit.Ifyouinitializetheashmemoryusing
the system status display, it is reset to the default setting
(see page 20).
Display
<Memo>:
When the brightness adjustment bar
is shown, pressing the [-] key long enough sets
the brightness to OFF, while pressing the [+] key
returns the brightness to the previous level before
entering the brightness adjustment mode.
When the brightness is set to any level lower than
the maximum level, pressing the [+] key long
enough directly sets the brightness to the maximum
level.
1
2 3 4 5
Turning off the
display
Brightness
[-] key (darker)
<Memo>:
If you press the [+] key when the bright-
ness is set to OFF, the display gets brighter.
[+] key (brighter)
<Note>:
If you set the brightness level to any level
between 1 through 5, the setting is stored to the
ashmemory.However,ifyousetittoOFF,theset
-
tingisnotstoredtotheashmemory,andwhenyou
turn on the unit the next time, the display is shown at
the brightness level that was set before entering the
brightness setting mode last time.
<Memo>:
In the following description, “press the key
long enough” means “hold down the key for more than
one second”.
(2) Press the [-] key to lower the brightness or press
the [+] key to increase the brightness.
You can select from OFF and 1 through 5.
14
Turning off the display
 previous next