Fostex FM-3 DJ Equipment User Manual


  Open as PDF
of 27
 
18
LIMITER parameter setting
By setting the [LIMITER] switch to “ON” (or “LINK”), the lim-
iter function is enabled and you can apply the limiter to the
stereo L/R buss.
The threshold level and ratio (compression ratio) of the lim-
iter are set to “+12” and “5.1” respectively by default.
(1) While the output status display is shown, press the
[EDIT] key long enough.
“ ”,thecurrentTHREvalue,startsashingquickly.
You can now edit the threshold level.
<Note>:
In the following description, it is assumed that the
[LIMITER] switch on the front panel is set to “ON” and the input
status display looks as below.
(2) By pressing the [EDIT] key, you can alternately
ashtheTHRE(“
”) and RATIO (“ ”) values.
Toeditthethresholdlevel,ashtheTHREvalue(“ ”).
Toedittheratio,ashtheRATIOvalue(“ ”).
(3) While the THRE value (“ ”) or the RATIO (“ ”)
isashing,usethe[+]or[-]keytoselectthedesired
value.
You can select the THRE value between “ ” and “ ”,
while you can select the RATIO value between “
” and
“
”.
Flashing
(4) After selecting the desired value, press the [EDIT]
longenoughtostopashing.
(5) Press the [EDIT] key to exit the status display mode.
To select the threshold value:
To select the ratio:
Press the [-] keyPress the [+] key
Press the [-] keyPress the [+] key
<Memo>:
The limiter parameter setting remains
evenafteryouturnofftheunit.Ifyouinitializetheash
memory using the system status display, it is reset to
the default setting.
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing
 previous next