Fostex FM-3 DJ Equipment User Manual


  Open as PDF
of 27
 
Press the [+] key
Press the [+] key
Press the [+] key
Press the [-] key
Press the [-] key
In the status display mode, not only you can check the
status for the input, output, meter and system, but also
you can edit setting.
(1) Press the [STATUS] key long enough to enter the
status display mode.
The display shows the input status display.
(2) Press the [+] or [-] key to select the desired status
display.
(3) Press the [EDIT] key to exit the status display
mode.
For details about the contents of each status display
and parameter setting, see the next page.
Press the [+] key
Press the [-] key
You can select the meter mode from stereo, mono L
and mono R. By default, it is set to the stereo mode.
The meter mode setting remains even after you turn
offtheunit.Ifyouinitializetheashmemoryusingthe
system status display, it is reset to the default setting (see
page 20).
(1) Press the [METER] key long enough to enter the
meter select mode.
The meter mode icon is shown at the bottom of the
display.
(2) Press the [+] or [-] key to select the desired meter
mode.
(3) Immediately after selecting the desired meter
mode, press the [EDIT] key to exit the meter
select mode.
Press the [+] key
Press the [-] key
Selecting the meter mode
Selecting the status display
Press the [-] key
System status display
Meter status display
Output status display
Input status display
Stereo meter mode
Mono meter (L) mode
Mono meter (R) mode
<Note>:
If you do not press any key for approxi-
matelyvesecondswhilethemetermodeiconis
shown, the icon automatically disappears and the
unit exits the meter select mode.
15
 previous next