Filter
Top Products
102
Advanced Operations (VF80EX)
To delete the program from the chain play list, select
“DEL”. To replace the program with another program,
select a desired program.
If you delete the program from the list, all the programs
set to the subsequent steps automatically slide up, as
shown below.
If you select a desired program, the program set to the
selected step is replaced and other steps are not affected
(in the following example, “P03” set to “C03” is replaced
with “P08”).
To delete (or replace) another program, repeat the
procedure shown above.
Press the [EXIT/NO] key to exit the “Chain Play List”
screen.
The display returns to the “Select Menu” screen where
the current option of the “Chain Play” mode setting is
flashing.
5
<Note>
If you delete or replace a program in the chain play list
when
“Chain Play”
is set to any option but
“Off”
, the
“Chain
Play”
setting automatically changes to
“Off”
(which is the
default).
Therefore, to execute chain play after editing the chain
play list, you must make the
“Chain Play”
mode setting
appropriately again.
Deleting all programs from the chain play list
You can delete all the program in the chain play list
simultaneously.
While the recorder is stopped, press the [SETUP] key
to enter the setup mode.
The screen for selecting a menu item in the setup mode
appears.
While step 1 (C01) is highlighted (selected), press the
[ENTER/YES] key.
The program number set to step 1 (C01) starts flashing.
If step 1 (“C01”) is not highlighted, use the [JOG] dial
(or the [CURSOR] keys) to select step 1 and press the
[ENTER/YES] key.
1
Use the [JOG] dial to select “END” and press the
[ENTER/YES] key.
All the programs in the list are deleted at once and the
screen shows as below (“C01: END” is shown in the chain
play list, which means no program is entered to the list).
3
<Note>
If you select any step but
“C01”
in procedure step 2) above
and follow procedure step 3), programs set to the selected
and subsequent steps are deleted from the list.
For example, if you set
“END”
to step 3 (C03) in the chain
play list where ten steps are currently set, programs set
to steps 3 through 10 are all deleted, while programs set
to steps 1 and 2 remain.
Press the [EXIT/NO] key repeatedly until the setup
mode exits.
The “Chain Play” mode setting is automatically changed
to “Off”.
4
2