Filter
Top Products
135
SETUP mode (VF80EX)
<Note>
You cannot delete the
“001BAR“
of
“001BAR 4/4
.”
• Editing a time signature event
On the "Signature Set" screen, select the desired
event and press the [ENTER/YES] key.
The current time signature value starts flashing.
Use the [JOG] dial to select the desired signature and
press the [ENTER/YES] key.
The setting is now effective.
After editing time signature event, press the [EXIT/
NO] key (or the [STOP] key) repeatedly until the
VF80EX exits the SETUP mode.
<Note>
By carrying out the procedure below, not only the time
signature events but also the tempo events are cleared.
On the "Signature Set" screen, select "All Clear" and
press the [ENTER/YES] key.
"SURE?" flashes on the right of "All Clear", asking
whether you may clear all signature and tempo data.
• Clearing all time signature/tempo events
On the "Signature Set" screen, select "-002BAR Off-
set" and press the [ENTER/YES] key.
"002" starts flashing.
• Editing the bar offset
Bar from 001 to 999.
Time Signature 1/4, 2/4, 3/4, 4/4, 5/4, 1/8, 3/8, 5/8, 6/8, 7/8,
8/8,or DEL
"DEL" is used to deleted time signature data.
See "Deleting time signature data" below for
details.
By rotating the [JOG] dial, you can select among from
following values for bar and time signature fields.
To insert another time signature event, repeat steps
2 through 5.
When completing time signature setting, press the
[EXIT/NO] key (or the [STOP] key) repeatedly until the
VF80EX exits the SETUP mode.
• Deleting a time signature event
Press the [ENTER/YES] key.
The selected event is deleted.
After deleting time signature event, press the [EXIT/
NO] key (or the [STOP] key) repeatedly until the
VF80EX exits the SETUP mode.
<Note>
After editing or deleting time signature events, if a
musical position at which a tempo is specified (see
"Setting a tempo" described later) disappears, the
associated tempo event is automatically deleted.
On the "Signature Set" screen, select the desired
event and press the [ENTER/YES] key.
The current time signature value starts flashing.
Use the [JOG] dial to select "DEL".
Press the [ENTER/YES] key.
All time signature events except the initial "001BAR
4/4 " event, as well as all tempo events are deleted
simultaneously.
After clearing all events, press the [EXIT/NO] key (or
the [STOP] key) repeatedly until the VF80EX exits the
SETUP mode.
Use the [JOG] dial to enter the desired offset value
and press the [ENTER/YES] key.
You can enter an offset value between -2 and -9.
After editing the bar offset, press the [EXIT/NO] key
(or the [STOP] key) repeatedly until the VF80EX exits
the SETUP mode.
flashing
flashing
flashing
flashing
6
7
1
2
3
1
2
3
4
1
2
3
1
2
3