Filter
Top Products
127
Save/Load of Song data (VF80EX)
When the recording ends, “Save Completed!” appears
on the screen, while the disc is automatically ejected
from the CD-R/RW drive.
After specifying the program(s), press the [ENTER/
YES] key while holding down the [RECORD] key.
The VF80EX starts recording to the disc, while the dis-
play shows the following screen.
<Note>
When making an audio CD, if you select a program
which consumes more disc space than the record-
able space of a CD-RW/CD-R disc,
“Disk Full!”
ap-
pears on the display and you cannot select the pro-
gram.
<Notes for selecting more than one program>
When recording more than one program to a CD-
RW/CD-R disc, do not skip any track when assign-
ing programs to tracks.
If you skip any track, you cannot record data to the
subsequent tracks. In the following example, track
03 is skipped when assigning programs.
So only tracks 01 and 02 will be recorded. Tracks
03 and subsequent tracks can not be recorded.
10
<Note>
It is possible to select a program that is not inter-
nal mastering if it holds the correct
“Start”
and
“End”
points. However, if you record such a program to a
CD-RW/CD-R disc with the audio CD format, only
track 1 and 2 can be recorded.
So, make sure that you select programs properly
when making an audio CD.
When completed, press the [EXIT/NO] key to quit the
Setup mode.
13
11
Set a blank CD-R/RW disc to the tray and close the tray.
After reading the disc, the VF80EX starts recording to
the disc.
This message asks you whether recording the same
material to another disc or finishing recording.
To finish recording, press the [EXIT/NO] key.
To record the same material to another disc, press the
[ENTER/YES] key and go to either step 11 below.
If you press the [ENTER/YES] key, the display changes
to show flashing "Insert Disk" for prompting you to
insert another disc to the drive.
Depending on the disc you are going to insert, go to
either of the steps below.
• When using a blank CD-R/RW disc
When the recording ends, "Save Completed!" appears
on the screen, while the disc is automatically ejected
from the CD-R/RW drive (as same as step 10 above).
If you record the same material to another disc, re-
peat the steps above.
11
Set a recorded CD-RW disc to the tray and close the tray.
After reading the disc, the display shows a warning mes-
sage ("Not Empty!"), followed by the screen for selecting
whether erasing data or ejecting the disc.
• When using a recorded CD-RW disc
To eject the disc, use the [JOG] dial to select "Eject"
and press the [ENTER/YES] key.
To erase data, go to the next step..
12
While "ERASE" is highlighted, press the [ENTER/YES]
key.
The VF80EX starts erasing the existing data.
After erasing all data, recording starts.
When the recording ends, "Save Completed!" appears
on the screen, while the disc is automatically ejected
from the CD-R/RW drive (as same as step 10 above).
If you record the same material to another disc, re-
peat the steps above.
When completed, press the [EXIT/NO] key to quit the
Setup mode.
12