Filter
Top Products
13
Special functions
SAVE SETTINGS
Routing settings can be saved by pressing together the ‘ch7’ and ‘ch8’ buttons on the front panel
of the M1. Hold down the 2 buttons for a few seconds.
RECALL SETTINGS
Recalling the saved routing settings can be done by pressing together the ‘ch9’ and ‘ch10’ buttons
on the M1 front panel. Hold down the 2 buttons for a few seconds.
ENABLE OR DISABLE THE KEYBOARD
The routing buttons (Z1 to Z4) of the input channels on the front panel of the M1 can be disabled
by pressing together the ‘ch7’ and ‘ch10’ buttons. Hold down the two buttons for at least 10
seconds !!
To enable the routing buttons on the front panel of the M1, press down the ‘ch7’ and the ‘ch10’
buttons simultaneously for at least 10 seconds.
MIXED MODE
Standard the M1 starts up in non-mixed mode. This means an output zone can only be assigned to
one input channel. The M1 can be set in mixed mode by pressing together the ‘ch8’ and ‘ch9’
buttons. Hold down the ‘ch8’ an ‘ch9’ buttons for at least 10 seconds !! It is now possible to
assign more then one input channel to the same output zone.
To disable the mixed mode setting, press down the ‘ch8’ and the ‘ch9’ buttons simultaneously
for at least 10 seconds.
REMEMBER
If you do not save the settings, the next time the M1 starts up it will recall the standard or
previously saved settings !!!!!