Filter
Top Products
from end to end can be purchased from your local GEM-
INI dealer.
NOTE: WHEN USING THE CROSS FADER LIGHTLY GLIDE
THE FADER BACK AND FORTH. PRESSING DOWN ON
THE CONTROLS CAN BEND CONTACTS AND CAUSE A
LOSS OF SOUND.
1. UNSCREW THE FADER SCREWS. DO NOT TOUCH IN-
SIDE SCREWS CAREFULLY REMOVE OLD CROSS FAD-
ER AND UNPLUG CABLE.
2. PLUG IN THE NEW CROSS FADER INTO CABLE AND
PLACE BACK INTO MIXER.
3. SCREW THE CROSS FADER TO MIXER WITH THE
FADER PLATE SCREWS
4. REPLACE THE FACE OF THE MIXER AND SCREW THE
FOUR SCREWS BACK IN AND REPLACE THE FADER
KNOBS.
- If a disc will not play, check to see if the disc was loaded
correctly (label side up). Also check the disc for exces-
sive dirt, scratches, etc.
- If the disc turns but there is no sound, check the cable
connections, if they are ok, check your amplier or re-
ceiver.
- If the CD skips, check the CD for dirt or scratches. Do
not assume that the CD player is defective. Many CD’s
are recorded out of spec and will skip on most or all CD
players. Before sending the unit for repair, try playing a
CD that you are sure plays properly.
GENERAL:
Type................................................................Compact Disc Player
Disc Type.......................Standard Compact discs (12 cm & 8 cm)
Time Display.........Track Elapsed, Track Remain, or Total remain
Variable Pitch...........................± 16% Slider with Resume Switch
Pitch Bend............................................................± 16% Maximum
Instant Start....................................................Within 0.03 seconds
Installation..........................................................................19” each
Dimensions..................... 19” x 4.3” x 10.2” (482 x 110 x 260 mm)
Weight.................................................Main unit: 12.13 lbs. (5.5 kg)
AUDIO SECTION:
Quantization..........................1 Bit Linear/Channel, 3 Beam Laser
Oversampling Rate..............................................................8 Times
Sampling Frequency..........................................................44.1 kHz
Frequency Response.............................................20 Hz to 20 kHz
Total Harmonic Distortion...................................Less Than 0.05%
Signal to Noise Ratio..............................................................85 dB
Dynamic Range.......................................................................85 dB
Channel Separation...................................................85 dB (1 KHz)
Output Level.......................................................2.0 +/- 0.2V R.M.S.
Power Supply.................................................AC 115/230V, 60/50 Hz
INPUTS:
Phono............................................................................3mV,47 KOhm
Line.........................................................................150 mV, 27 KOhm
MIC.................................................................1.5 mV, 1 KO balanced
OUTPUTS:
Max........................................................................ 20V Peak-to Peak
Rec.............................................................................. 225 mV, 5 KOh
SPECIFICATIONS AND DESIGN ARE SUBJECT TO CHANGE
WITHOUT NOTICE FOR PURPOSE OF IMPROVEMENT.
CDM-3610
TROUBLESHOOTING:
SPECIFICATIONS:
FADER REPLACEMENT:
7