Filter
Top Products
-12-
H3123 Electric Guitar Kit
5. Place the black neckplate setter and the sil-
ver neckplate over the holes on the back of
the guitar body.
6. Secure the neckplate assembly, the guitar
body, and the neck together with the includ-
ed 1
3
⁄4" wood screws (Figure 14). DO NOT
use glue.
4. Using a
5
⁄32" drill bit, drill 1
3
⁄4" deep holes
straight through the four holes in the back of
the body (Figure 13). Note—Drilling the
holes deeper than 1
3
⁄4" could result in drilling
out through the fingerboard.
Figure 13. Drilling the screw holes.
Figure 14. Correctly attached neck.
Pick Guard
To attach the pick guard to the guitar body:
1. Push one white and one black wire through
the hole shown in Figure 15.
2. Push the remaining black wire through the
hole shown in Figure 16.
Figure 15. Pick guard wires.
Figure 16. Pick guard wire.