Filter
Top Products
3 Troubleshooting Your PC
If Your PC Has a Hardware Problem
40 English
If the Flexible Disk Drive Does Not Work
• Ensure you are using a formatted diskette and it is inserted
correctly.
• Check you are using a diskette that is the right density.
• Check that your flexible disk drive is correctly configured in the
Setup Configuration menu.
• Check the option on the Setup Configuration menu which
enables or disables the on-board flexible disk controller.
• Clean the flexible disk drive using a diskette cleaning kit.
• Check that the flexible disk drive has been enabled in Setup.
• Flexible disk drive (refer to the Hardware Protection Submenu of
the Security Menu in the Setup Program)
• Boot on flexible disk drive (refer to the Start-up Center Submenu
of the Security Menu in the Setup Program)
• Write on flexible disk drives (refer to the Start-up Center
Submenu of the Security Menu in the Setup Program).
• Check that the disk power and data cables are correctly connected.
If the Hard Disk Does Not Work
• Check that the disk power and data cables are correctly connected
(refer to "Internal Connectors", on page 20).
• Check that the hard disk drive has been “enabled” (refer to the
Hardware Protection Submenu of the Security Menu in the Setup
Program). There is also an option in the Setup program that lets you
disable or enable boot on hard disk drive (refer to the Start-up
Center Submenu of the Security Menu in the Setup Program).
• Check that the hard disk drive has been detected (refer to the IDE
Devices Submenu of the Configuration Menu in the Setup Program).
• Check that the on-board Bus IDE is enabled if you are using the
integrated IDE controller (refer to the IDE Devices Submenu of the
Configuration Menu in the Setup Program).