Filter
Top Products
16
d.2 DJ Mixer
d.2 2-channel DJ Mixer
45. REVERSE LED
This LED lights when
the REVERSE switch
[48] has been activated
for the Crossfader. For
more details, see the dis-
cussion of the REVERSE
switches [48] on the
next page.
46. CROSSFADER
The crossfader is used
to fade between the
two PGM signals in the
MAIN outputs. When
the crossfader is all the
way to the left, PGM 1 is
heard in the MAIN outs.
When the crossfader is
all the way to the right,
PGM 2 is heard. When
the crossfader knob is
in the center, the MAIN outs get an even mix of PGM 1
and 2.
The characteristics of how the crossfader affects the
audio signal are determined by its corresponding CON-
TOUR control [47] and the REVERSE switch [48].
The crossfader is a high-quality
infi nium
™
contact-free optical digital fader,
designed to last the lifetime of the d.2 with
no degradation in quality.
You can adjust the tension of the fader movement to
your specifi c taste.
To adjust the crossfader tension:
1. Move the crossfader all the way to the left.
2. Remove the fader cap (knob) by grasping it
fi rmly and pulling straight up.
3. Use a small slot-head screwdriver to turn the
screw located through the hole on the left side
of the crossfader slot.
Rotate the screw clockwise to tighten the ten-
sion, and rotate the screw counter-clockwise to
loosen the tension. You might need a fl ashlight
to make sure you are lined up on the screw.
4. Replace the fader cap, and you’re all done.
LR
MAIN
BA
OL
10
7
4
2
0
2
4
7
10
20
30
OL
10
7
4
2
0
2
4
7
10
20
30
OL
10
7
4
2
0
2
4
7
10
20
30
TRANSFORM
PGM
2
TRANSFORM
REVERSE
contact-free
cross-fader
infini um
PGM
1
REVERSE REVERSE