Mackie PPM608 DJ Equipment User Manual


 
16
PPM608
PPM608
Channel Controls
The eight vertical channel strips look very similar,
with only a few differences between them. Each chan-
nel works independently, and just controls the signals
plugged into the inputs directly below it.
Mono Channels 1 to 6
• Channels1to6aremonochannels,andtheir
controls affect either the mono mic input or the
mono line-level input.
• Channels1to4haveabuilt-insignalin-line-
compressor circuit with adjustable threshold.
• Channels5and6haveahi-zswitch[30]soyou
can connect guitars directly.
• The3-bandEQhasshelvinghigh,shelvinglow,
and peaking mid EQ.
• Themonosignalsaresplitequallytotheleft
and right of the main mix.
Stereo Channels 7 to 8
• Channels7and8arestereochannels,andtheir
controls affect either the mono mic input, ste-
reo line-level input, or stereo RCA inputs. (The
mono mic input of each stereo channel is split
equally to left and right).
• ThestereochannelEQisa3-banddesignjust
like the mono channel EQ.
“U” like Unity gain
Mackie mixers have a “U” symbol on almost every level
control. It stands for “unity gain,” meaning no change in
signal level. The labels on the controls are measured in
decibels (dB), so you’ll know what you’re doing level-
wise if you choose to change a control setting.
Signal Flow
The block diagram on page 29 shows the signal flow,
but here is a short description of the flow through the
channel strip section:
The mic inputs and mono line inputs each feed a
preamplifier whose gain is set by the gain switch [28].
The stereo channel line inputs and RCA inputs do not go
through a gain-selectable preamp.
The signal then passes through the compressor circuit
(ch. 1 to 4 only), then through the channel EQ, and the
channel level [27].
The mon 1 control [21] taps the signal off just before
(pre) the channel level.
The FX/mon 2 control [22] taps the signal off before
(pre) and after (post) the channel level. The FX send/
mon 2 send switch [47] lets you choose which is used.
Post is used for FX, and pre is for monitor 2.
21
22
23
24
25
27
28
29 30
26
30