Filter
Top Products
72 Chapter 7: Output Section
VeniceU
Operator Manual
Playback and recording
The following four connectors on the rear panel provide discrete analogue inputs and
outputs for audio playback and recording, respectively.
Playback/record sockets on the rear panel
Playback
The two in (right and left) connectors let you connect an analogue device, such as an
MP3 device or tape recorder, to play back recorded audio material via the console.
playback to masters section on the control surface
Recording
The two out (right and left) connectors are recording outputs. They are routed via the
stereo bus output and operate at a nominal -10dB. These outputs provide a direct
output from the console that is post-everything, including mute.
Item Description
1 playback to masters control knob The level of the input is continuously
variable from
4 (infinity/off) to +10dB (the nominal level is referenced to
-10dB).
2 MUTE switch and red LED The MUTE switch mutes the input signal.
The LED illuminates to show when the mute is on.
3 SOLO switch and yellow LED The SOLO switch routes the input signal
to the mono PFL bus and stereo AFL buses. The solo LED illuminates to
show when solo is on.
1
2
3