Filter
Top Products
15
MIXING THE INPUTS
You can connect input signals from up
to six audio sources, select any two,
then mix them so only one or both
play through your sound system.
Mixing requires three operations:
• Playing one input source
• Monitoring the next input source
• Switching to the next input source
You can play either of the two select-
ed sources first.
Notes:
• Ensure the volume level slide con-
trol for the other input channel
source is set to 0.
• The CUE ASSIGN switches are
push-on and push-off. You can se-
lect more than one at a time.
Playing One Input Source
1. Set
ASSIGN A
to the desired
source, then
set
CROSS FADER
to
A
.
illustration of ASSIGN A
set to 1 and CROSS
FADER set to A
2. Set the input source selector to
the preset input source you want
to play first through your sound
system.
3. Make sure the first input source’s
volume level slide control is set to
the correct preset position.
4. Start playback of the input source.
Monitoring a Second
Input Source
Monitoring a second input source’s
signal level requires selecting the in-
put source that is
not
currently play-
ing, finding the desired section you
want to mix, then adjusting that
source’s sound level so it matches the
volume level of the source currently
playing.
1. Connect and put on headphones.
Note:
You can listen to one chan-
nel through the headphones while
the other channel is playing
through the sound system.
2. Set
ASSIGN B
to the second input
source.
illustration
32-3009.fm Page 15 Tuesday, August 10, 1999 8:31 AM