Filter
Top Products
6
PREPARATION
Warnin
g
:
A sudden high output from
the mixer could damage your hearing,
especially if you use headphones, and
might also damage the audio devices
connected to the mixer’s output. Be-
fore using the mixer, make sure you
set your receiver/amplifier’s volume
control to its minimum volume level
setting.
Before you connect the AC power
cord, make sure you set
POWER
to off.
And, to avoid sudden and unusable
sound outputs from any audio devices
that you connect to the mixer, be sure
to have their power controls set to off
(and any tone controls set to flat).
CONNECTING THE
OUTPUTS
To play the mixer’s output signal
through your sound system (for events
such as parties, dances, conferences,
and so on), connect one end of an au-
dio patch cord (Cat. No. 42-2356, not
supplied) to the mixer’s
AMP
L
(white)
and
R
(red) output jacks, then connect
the other end to your receiver/amplifi-
er’s left and right line input jacks
(matching left to left, and right to right).
To record the mixer’s output signal,
connect one end of an audio patch
cord (Cat. No. 42-2356, not supplied)
to the mixer’s
REC
L
(white) and
R
(red) output jacks, then connect the
other end to your tape deck’s left and
right line input jacks (matching left to
left, and right to right).
CONNECTING THE
INPUTS
You can connect up to four line-level
and up to two low-level audio input
sources to the input jacks on the back
of the mixer. You can also connect a
microphone to the mixer’s front or
back panel.
illustration of output AMP
to sound system
illustration of output REC
to recorder
AMP connections should
still appear
32-3009.fm Page 6 Tuesday, August 10, 1999 8:31 AM