Filter
Top Products
11
Minimal Installation for Service Providers
In the following procedures, once the unit is installed and minimal configuration is
completed using the Easy Install feature, the NOC can complete and verify the setup.
Physically Installing the Unit and Setting Up for Remote Access
It is assumed that frame relay service is turned on at the site. For a FrameSaver SLV
9128-II, this procedure is for setting up the unit in Frame Relay mode; the FrameSaver
SLV 9128 is always in Frame Relay mode.
Procedure
1. Follow Steps 1 through 8 of
Full Installation and Setup
on page 8.
2. If the DSX-1 interface will be used, install the DSX-1 cable (see
Connecting to DSX
on page 21).
3. Install the modem cable (see
Connecting the Modem
on page 21).
4. If the unit is equipped with an ISDN DBM, install the ISDN DBM cable (see
Connecting to ISDN
on page 21).
5. If a FrameSaver SLV 9128-II will use its Ethernet port for management, install the
Ethernet cable (see
Connecting to Ethernet
on page 22).
6. Install the DTE cables (see
Connecting to a DTE
on page 22).
Physical installation of the unit is complete; the NOC can now remotely access the unit
for additional configuration.