Filter
Top Products
8
About the Installation Procedures
There are two methods for installing and setting up the FrameSaver unit.
One person can install and set up the unit. If this is the case, see
Full Installation
and Setup
.
An installer can physically install and set up access to the unit, and the network
operation center (NOC) can complete the setup. If this is the case, see
Minimal
Installation for Service Providers
on page 11.
Certain procedures are common to both the full installation and minimal methods. These
procedures are referenced in the full and minimal installation instructions (starting with
Setting Up Local Management at the Central Site
on page 13). Refer to them, as
needed.
Full Installation and Setup
An Easy Install screen is provided to simplify installation and setup. It can be used for
the first part of the installation when one person is installing and setting up the unit from
beginning to end.
Easy Install Screen Example
* The Ethernet Port Options Screen only applies to the Model 9128-II.
** DS0 Base Rate (Kbps) only applies to the Model 9128.
main/easy_install 9128-II
Device Name: Node A 8/18/2000 23:32
EASY INSTALL
Node IP Address: 000.000.000.000 Clear
Node Subnet Mask: 000.000.000.000
Clear
TS Access: DLCI
980
Create a Dedicated Network Management Link
Ethernet Port Options Screen *
Time Slot Assignment Screen
Network 1 Line Framing Format: ESF
Network 1 Line Build Out (LBO): 0.0
Network 1 Line Coding Format: B8ZS
DS0 Base Rate (Kbps): ** Nx64
-----------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu M
ainMenu Exit
S
ave