Filter
Top Products
5555.. AAUUXX 11 -- 66 OOUUTT ((UUNNBBAALLAANNCCEEDD))
These 1/4" (TS) jacks provide signal from the Aux buses.
5566.. AAUUXX 11 -- 44 OOUUTT ((BBAALLAANNCCEEDD))
These XLR connectors are provided on Aux 1–4 and provide output
from those buses. These can be used simultaneously with the unbalanced jacks, but both levels will
be determined by the Aux Send level.
5577.. RREEMMOOVVAABBLLEE PPOOWWEERR CCOORRDD
This receptacle is for the IEC line cord (included) that provides AC
power to the unit. Connect the line cord to this connector and to a properly grounded AC supply.
Damage to the equipment may occur if an improper line voltage is used (see voltage marking on
unit). Never remove or cut the ground pin of the line cord plug. The console is supplied with a
properly rated line cord. If lost or damaged, replace this cord with one of the proper rating.
NNOOTTEE:: FFOORR UUKK OONNLLYY
If the colors of the wires in the mains lead of this unit do not correspond with the colored markings
identifying terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow
must be connected to the terminal marked by the letter E, or by the earth symbol, or colored green
or green and yellow. (2) The wire that is colored blue must be connected to the terminal that is
marked with the letter N, or colored black. (3) The wire that is colored brown must be connected to
the terminal that is marked with the letter L or colored red.
58. POWER SWITCH Place this switch in the “|” position to apply power to the console. Return it to
the “O” position to turn the unit off. It is recommended that the unit be turned off while patching
and/or applying power to external equipment to be used in conjunction with the mixer. The Power
LED will illuminate when power has been applied and the unit is on.
If you require assistance with your new mixer, you can get help from several sources. There are many
technical documents, white papers, and application notes on our website. There are also brochures,
data sheets, and our bi-monthly newsletter, Audio Interactive. Also on our website are message
board forums that include questions and answers on all audio topics. This forum is a great way to
learn more about audio, Peavey products and system design from other audio professionals around
the world. You can also get help by sending us an e-mail or posting a request on the message board.
Finally, if you still cannot get the information you need, don’t hesitate to call us. Peavey has an
extensive service department that provides tech support, parts, repair and extensive phone support
services. They will be happy to assist you. The contact information for the Architectural Acoustics
division is shown below:
Peavey Electronics Corp.
Architectural Acoustics Division
711 A St. • Meridian, MS 39301 • USA
Phone: 601-483-5376 • Fax: 601-486-1678
Website: http://aa.peavey.com
Please take a few minutes and fill out the warranty registration card for your mixer. Although your
warranty is valid without the registration, the information you provide with the form is crucial to our
support group. It enables us to provide better service and customer support, and to keep you
informed of new product updates. Refer to the warranty statement in the rear of this manual for
details about what your warranty includes and what the limitations are.
11
TTeecchhnniiccaall SSuuppppoorrtt
WWaarrrraannttyy