Filter
Top Products
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
d
ispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
n
on-abrasive cleaner.
Assembly requires the included hex keys and your own phillips screwdriver , rubber
mallet , and adjustable wrench .
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST on page 23. The number after the parentheses shows the quan-
tity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preattached to one of the parts
to be assembled.
To avoid damaging plastic parts, do not use power tools for assembly.
5/16” Star
Washer (101)–4
1/4” Star
Washer (95)–4
1/2” Screw (119)–1
3/4” Tek Screw (58)–8
1
Wheel Nut (32)–2
Wheel Bolt (64)–2
1” Tek Screw (39)–4
Extension Leg
Nut (46)–2
3/4” Screw (2)–8
Handrail Bolt (37)–4
2.25” Bolt (93)–2
Silver Ground
Screw (G)–1
Handrail
Bolt (37)–4
3.5” Bolt (96)–4
3/8” Star
Washer (83)–4
P
ulse Bar Star
W
asher (65)–4
3/8” Star
Washer (5)–4
1/4” Washer
(38)–4
2.75” Bolt (100)–2
6
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side as shown. Partially
fold the Frame (86) so the treadmill is more sta-
ble.
Do not fully fold the frame until the tread-
mill is completely assembled.
Insert an Extension Leg (63) into the base of the
Uprights (69). Hold an Extension Leg Nut (46) in
the bottom of the Extension Leg, and thread a
2.25” Bolt (93) with a 5/16” Star Washer (101)
into the top of the Extension Leg. Next, thread a
2.75” Bolt (100) with a 5/16” Star Washer into the
bottom of the Extension leg.
Firmly tighten the
Bolts.
63
86
69
93
101
46
100
1
101