Filter
Top Products
9. Attach the Latch Housing (29) and the Latch
Spacer (98) to the left Upright (69) with two 3/4”
Screws (2). Make sure that the large hole in
the Latch Housing is on the side shown. Do
not overtighten the Screws.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin as
shown. Insert the pin into the Latch Housing (29),
and tighten the knob back onto the pin.
8. Attach the Left Upper Body Arm (76) to the left
Upright (69) with two 3.5” Bolts (96), two 1/4”
W
ashers (38), and two 3/8” Star Washers (5) as
shown.
Make sure that the Left Upper Body
A
rm is on the indicated side of the Console
(43).
Attach the Right Upper Body Arm (not shown) to
the right Upright (not shown) in the same way.
9
10. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt
(see page 19). To protect the floor or carpet, place a mat under the treadmill.
2
98
29
69
Knob
Large Hole
Pin
Collar
Spring
76
43
5
5
38
69
96
8
9