Filter
Top Products
Editing sounds | Selecting parameters
40
r
FR-7b/FR-5b V-Accordion
(5) Press a register [1]~[14] to specify a parameter
within the selected group.
See the table on page 41. Press the [ORCHESTRA]
register to select parameter “15” (only available for
groups “2” and “10”).
You can only select sections that are active (and thus
sound when you play on the Treble or Bass keyboard).
If you select a function of a section that is currently
off, the display tells you that its parameters cannot
be changed. In that case, switch the section on and
try again – or select another group.
(The message above means that the Orchestra section
is not active and therefore cannot be edited.)
(6) Proceed with “Setting parameter values” on p. 41.
(7) Press [EXIT÷JUMP] several times to return to the
main page.
Selecting parameters via the menu
A second way of selecting parameters goes like this:
(1) Press the [MENU] button.
(2) Use the [DATA÷ENTER] knob or the [UP]/[DOWN]
buttons to select one of the function groups.
See the previous page for a list with short explana-
tions.
(3) Press the [DATA÷ENTER] knob to enter that group.
The display now responds with (this depends on the
function group you selected):
You can only select sections that are active (and thus
sound when you play on the Treble or Bass keyboard).
If you select a function of a section that is currently
off, the display tells you that its parameters cannot
be changed. In that case, switch the section on and
try again – or select another group.
(The message above means that the Orchestra section
is not active and therefore cannot be edited.)
(4) Use the [DATA÷ENTER] knob or the [UP]/[DOWN]
buttons to select the parameter you wish to edit.
(5) Proceed with “Setting parameter values”.