Filter
Top Products
Editing sounds | 7. ORC CHD EDIT parameters
60
r
FR-7b/FR-5b V-Accordion
7. ORC CHD EDIT parameters
The parameters of the ORC CHORD EDIT group apply to the chord button rows of the Bass section. As
stated earlier, the FR-7b/FR-5b allows you to play and accordion sound with the bass rows and an
orchestral sound with the chord rows of the bass keyboard (and vice versa). See page 29 for details
about the Orchestra Chord section. (You can also combine the Orchestra Chord section with the
Orchestra Bass section if you like.) See pages 39 and 41 for how to select and adjust the parameters.
Press [UP] and [DOWN] simultaneously to select the value that is indicated as “Default setting”.
The selection of Orchestra Chord can be automated
using the “2.14 Orchestra Chord Link” parameter
(page 48) – for each Treble register.
Any changes you make can be saved using the WRITE
function. Though there is no need to save your changes
right after performing them, please bear in mind that
they will be lost in the following cases:
• When you select another Set
• When you switch off the FR-7b/FR-5b
Changes you want the FR-7b/FR-5b to remember must
be saved as soon as possible. Here is how:
(1) Press and hold the [MENU÷WRITE] button until the
following page appears:
(2) Rotate the [DATA÷ENTER] knob (or use the [UP]/
[DOWN] buttons) to select “Orc. Chord”.
(3) Press the [DATA÷ENTER] knob to confirm your
selection.
(4) Use the [DATA÷ENTER] knob or the [UP]/[DOWN]
buttons to specify what you want to save:
(5) Press the [DATA÷ENTER] knob to confirm your
selection.
Depending on what you chose in step (3) above, the
display now looks as follows:
(6) Use the [DATA÷ENTER] knob or the [UP]/[DOWN]
buttons to select the Set that should contain your
changed version(s).
Change this setting only if you do not want to save
your settings to the current Set.
(7) Press the [MENU÷WRITE] button to save your
changes. The display briefly shows a confirmation:
(8) Press the [EXIT÷JUMP] button to return to the Main
page.
Note: See pages 39 and 41 for how to select and adjust the
parameters below.
7.1 Orc Chord Volume
(Off, –40~“Std”~40, Default set-
ting: Std) This parameter allows
you to create the desired “mix”
(volume balance) between the
Orchestra Chord section and the
other active sections.
This is a relative parameter, which means that its value
is added to or subtracted from the standard value
(“Std”).
Important note
Saving your changes
Current: The register you are currently editing.
Currnt +
SCom:
The register you are currently editing as
well as the Set Common settings
(page 64).
ALL All registers. This is probably the safest
bet, because it ensures that no Orchestra
Chord register will be forgotten. (It is per-
fectly possible to edit several registers
without saving them.)
If you selected “Current” or
“Curnt+SCom”
If you selected “ALL”
(You cannot select a different register,
or change the name of the current
one.)