Filter
Top Products
Before you start using the JM-5
14
r
VIMA JM-5
4. Before you start using the JM-5
Connecting the AC adaptor
1.
Turn the [MASTER VOL] knob all the way to
the left to minimize the volume.
2.
Connect the included power cord to the AC
adapter.
The indicator will light once you plug the AC adaptor
into a wall outlet.
Place the AC adapter so the side with the indicator
(see illustration) faces upwards and the side with tex-
tual information faces downwards.
NOTE
Depending on your region, the included power cord may
differ from the one shown above.
3.
Connect the AC adaptor to the JM-5’s DC IN
jack.
4.
Plug the power cord into a power outlet.
Note: Be sure to use only the AC adapter supplied with the
unit (PSB-1U). Also, make sure the line voltage at the
installation matches the input voltage specified on the AC
adapter’s body. Other AC adapters may use a different
polarity, or be designed for a different voltage, so their use
could result in damage, malfunction, or electric shock.
NOTE
If you won’t be using the JM-5 for an extended period of
time, disconnect the power cord from the electrical outlet.
Connecting the JM-5 to an
amplifier, mixer, etc.
To use the JM-5, you need to connect it to a mixer or an
amplification system.
NOTE
To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
1.
Turn the [MASTER VOL] knob all the way to
the left to minimize the volume.
2.
Switch off all devices.
3.
Connect the JM-5’s OUTPUT jacks to the
inputs of your external device.
Connect the outputs of an external signal
source to the JM-5’s INPUT (STEREO) socket.
For the connection to an amplifier, please choose
unbalanced (mono) cables with 1/4” plugs at one end
(for the JM-5). The connectors at the other end need
to match the input sockets of the device to which
you are connecting the JM-5.
NOTE
When connection cables with resistors are used, the vol-
ume level of equipment connected to the audio inputs may
be low. If this happens, use connection cables that do not
contain resistors.
AC adapter Power cord
Indicator
to an AC outlet
JM-5’s rear panel
OUTPUT R + L/MONO
INPUT L + R
Connecting the JM-5 to an amplifier
JM-5_US.book Page 14 Tuesday, December 14, 2010 10:29 AM