Filter
Top Products
20
Getting Ready to Play
Switching the Power On and Off
■ Switching On the Power
1
Before you switch on the power, check the following.
• Are peripheral devices connected correctly?
• Is the volume level on the JV-1010 and the connected external
equipment turned down all the way?
2
Press the POWER switch on the JV-1010 to switch on the power.
After roland Jv-1010 is displayed, the unit starts up in the same state it was
in when the power was last turned off.
¬fig.1-07
3
Switch on the power to the connected external equipment.
4
Play sounds on the JV-1010 and turn the VOLUME knob to
adjust the volume on the JV-1010 and the external equipment.
fig.1-08
■ Switching Off the Power
1
Before you switch off the power, check the following.
• Is the volume level on the JV-1010 and the connected external
equipment turned down all the way?
•Have you saved the sounds or other data you’ve created? (p. 48)
2
Switch off the power to the connected external equipment.
3
Switch off the POWER switch on the JV-1010.
Once the connections have
b
een completed (p. 18), turn
on power to your various
devices in the order
specified. By turning on
devices in the wrong order,
you risk causing malfunction
and/or damage to speakers
and other devices.
If the power was turned off
while in the Rhythm Set
mode (RHYTHM), the unit
starts up in the Performance
mode (PERFORM).
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
b
efore the unit will operate
normally.
Be careful not to turn the
volume up too high.
Excessive volume levels are
not only inconsiderate to
others around you, but may
damage external equipment
or cause hearing loss.
Turning the VOLUME knob
up all the way may result in
distortion for some sounds.
You can also play sounds
on just the unit itself by
pressing the VOLUME
knob (Phrase Preview, p.