Filter
Top Products
43
Trying Out Desktop Music
Quick Start
1
Press the VALUE knob to choose the Performance mode
(PERFORM).
Pressing the VALUE knob makes the mode change sequentially. Press the
knob several times, until the PERFORM indicator lights up.
2
Turn the PART knob and choose 2.
3
Set the transmit channel of the external device (the
transmitting device) to 2.
For information on how to make the settings, refer to the owner’s manual
for the MIDI keyboard (the transmitting instrument).
4
Turn the CATEGORY/BANK knob to choose GUITAR/BASS.
Now, select the patch category.
5
Turn the VALUE knob to choose patch 008.
Now, patch No.008 Gtr Strings in the GUITAR/BASS category is selected
for PART 2.
6
Repeat Steps 2–5, using the same procedure to select other
parts.
7
Using a sequencer or computer, play back the song.
For instructions on how to play back songs, refer to the owner’s manual for
the external device (the transmitting device).
Always make sure that the
number selected with the
J
V-1010’s PART knob
matches the transmit
channel of the external
device (the transmitting
device). Additionally,
remember that PART 10 is
used exclusively by the
rhythm set.
Turning off the JV-1010’s
power without saving the
created data results in the
loss of that data. Save any
important data that you
wish to preserve to an
external MIDI device (p.
The Performance Control
Channel (Perform Ctrl CH)
is preset at the factory to
OFF; remember that
patches are switched when
program changes are
recorded in a song. To
release the Performance
Control Channel (Perform
Ctrl CH) OFF setting, set to
something other than OFF
(p. 49).
For more information about
the onboard patches, take a
look at
“Performance
List”
(p. 67).