Filter
Top Products
33
Changing Sounds from an External MIDI Device
Quick Start
2
Press the VALUE knob to choose the Patch mode (PATCH).
Pressing the VALUE knob makes the mode change sequentially. Press the
knob several times, until the PATCH indicator lights up.
3
Turn the PART knob and choose 1.
Here, 1 becomes the JV-1010’s receive channel.
4
Transmit a Bank Select MSB (Controller Number 0) value of 81
from the external MIDI device to the JV-1010
5
Transmit a Bank Select LSB (Controller Number 32) value of 1
from the external MIDI device to the JV-1010.
6
Transmit a Program Change 10 from the external MIDI device
to the JV-1010.
The display on the JV-1010 shows 010 to indicate the switch to the PRESET-
B patch No. 010 Hip Bass.
The correspondences between MIDI messages transmitted from external
MIDI devices and Patch Numbers are as shown below.
Patch Patch Bank Select Program
Group Number MSB LSB Number
USER 1–128 80 0 1–128
PRESET-A 1–128 81 0 1–128
PRESET-B 1–128 81 1 1–128
PRESET-C 1–128 81 2 1–128
PRESET-D 1–128 81 3 1–128
PRESET-E 1–128 81 4 1–128
Session 1–128 84 0 1–128
Session 129–255 84 1 1–127
WAVE-EXP 1–128 84 2 1–128
WAVE-EXP 129–256 84 3 1–128
Be sure to set the transmit
channel for the external
MIDI device and the
receive channel for the JV-
1010 to the same channel.
On the JV-1010, when just a
Program Change message
is received without
receiving a Bank Select
message, only patches and
rhythm sets within the
same group are changed.