Filter
Top Products
22
Conversion for Left-Handed Use
If you are left handed, it is possible to configure the HD-1 for you.
Follow these instructions:
* You will need two 50 cm extension cables.
1. Remove both the crash and ride cables from the cymbal
rod, then connect an extension cable to each of them.
Next, switch the connections for these two cables.
4. Switch the cable connections to the KICK and Hi-Hat
CONTROL pedals.
(refer to the set-up instruction sheet if necessary)
2. Switch the cable connections to the Tom1 and Tom2 pads.
3. Remove and switch the positions and connections of the
Tom3 and Hi-Hat pads.
*Pay attention to the angle when attaching tom 3 (p. 18).
HD-1_r_e.book 22 ページ ２００７年３月２８日 水曜日 午後６時５８分