Filter
Top Products
XML POWERED MIXERS
18
Speaker Connection - XML610 & XML910
The XML610 and XML910’s power amplier section can be congured to operate several ways depending on the set-
ting of the Power Amp MODE switch located on the front panel. This allows you to choose whether you need MAIN plus
MONITOR ampliers to power your speakers, or if you just need more power for the MAIN speakers.
There are two ways in which speakers can be connected to the XML power mixer:
1) A single speaker can be connected to either the A or B jack of AMP 1 and AMP 2, or
2) Two speakers can be connected in parallel to both the A and B jacks of AMP1 and AMP 2.
For both of these situations, the required speaker impedance will dier. Refer to the following diagram, and make sure
that the speaker impedance is not less than the specied value.
When connecting one speaker to AMP1
and one speaker to AMP 2, use speakers
with a 4–8 Ohm impedance rating.
When connecting two speakers to AMP 1 and two speaker to
AMP 2, use speakers with an 8–16 Ohm impedance rating.
Neutrik NL4 Speakon Wiring
Additional, or alternative ampliers can be connected to the MAIN OUT and MONITOR output jacks on the front panel.