Samson XML910 Music Mixer User Manual


 
Important Safety Information
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. This apparatus shall not be exposed to dripping or splashing liquid and no object lled with liquid, such as a vase,
should be placed on the apparatus.
6. Clean only with a dry cloth.
7. Do not block any of the ventilation openings. Install in accordance with the manufacturer's instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatuses (including ampli-
ers) that produce heat.
9. Only use attachments/accessories specied by the manufacturer.
10. Unplug this apparatus during lightning storms or when not in use for long periods of time.
11. Do not override the intended purpose of the polarized or grounding-type plug. A polarized plug has two blades, with
one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade, or
third prong, is provided for your safety. If the provided plug does not t your outlet, consult an electrician to replace
the obsolete outlet.
12. Protect the power cord from being walked on or pinched, particularly at the prongs, convenience receptacles, the
point where they exit from the apparatus.
13. Use only with the cart stand, tripod bracket, or table specied by the manufacture, or sold with the
apparatus. When a cart is used, utilize caution when moving the cart/apparatus combination to
avoid injury from tip-over.
14. Refer all servicing to qualied service personnel. Servicing is required if the apparatus has been
damaged in any way, such as power-supply cord or plug breakage, damage due to liquid or objects
falling onto the apparatus, exposure to rain or moisture, or if the apparatus does not operate normally, or has been
dropped.
15. POWER ON/OFF SWITCH: For products with a power switch, the power switch DOES NOT break the connection from
the mains.
16. MAINS DISCONNECT: The plug should remain readily operable. For rack-mount or installation where plug is not ac-
cessible, an all-pole mains switch with a contact separation of at least 3mm in each pole shall be incorporated into
the electrical installation of the rack or building.
17. FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE RECEPTACLE: Replace fuse with same type and rating
only.
18. MULTIPLE-INPUT VOLTAGE: This equipment may require the use of a dierent line cord, attachment plug, or both,
depending on the available power source at installation. Connect this equipment only to the power source indicated
on the equipment rear panel. To reduce the risk of re or electric shock, refer servicing to qualied service personnel
or equivalent.