Samson XML910 Music Mixer User Manual


 
Owner's Manual
23
XML POWERED MIXERS
Using an External Eect
Sending an Independent Mix to an External Eects Processor
If you prefer to use an external device for eects processing, you can easily connect the unit using the XML EFX bus. Fol-
low the steps below to interface your processor.
1. Set the MONITOR section MASTER control to the “0” position. Press the EFX BYPASS switch to disable the internal DSP.
2. Raise the AUX 2/EFX controls for the channels to which you want the external eect to be applied.
3. Adjust the EFX LEVEL to the “5” position.
4. Set the input level of the external eect so that the sound is not distorted, and so that the eect’s input meter does not
indicate a clipped signal.
5. Connect the output of the external eect to an available input channel. Be sure to turn the AUX 2/EFX control for that
channel all the way down. Use the channel’s VOLUME control to adjust the eect return level.