Filter
Top Products
10
Preparing the receiver for use
Mounting the receiver feet
To ensure that the receiver cannot slip on the surface on which it is placed,
four self-adhesive soft rubber feet are supplied.
̈ Ensure that the base of the receiver is clean and free from grease before
mounting the rubber feet.
̈ Fix the rubber feet to the base of the receiver by peeling of the safety
paper and fitting them as shown in the digram on the left.
Attention!
Some furniture surfaces have been treated with varnish, polish or syn-
thetics which might cause stains when they come into contact with other
synthetics. Despite a thorough testing of the synthetics used by us, we
cannot rule out the possibility of staining.
Connecting the antennas
The supplied telescopic antennas can be mounted quickly and easily and are
suitable for all applications where – good reception conditions provided – a
wireless transmission system is to be used without a large amount of
installation work.
̈ Connect the telescopic antennas ƺ to the BNC sockets ¹ and ƹ at the
rear of the receiver.
̈ Pull the telescopic antennas out and align the upwards in a V-shape.
Use remote antennas (available as accessories) when the receiver position is
not the best antenna position for optimum reception.
Connecting the mains unit
The receiver is powered via a mains unit.
̈ Pass the cable through the cable grip ¶.
̈ Insert the DC connector on the mains cable into the DC socket º.
¹
ƺ
ƹ
¶ º