Filter
Top Products
23
Entering a name
Name
Via the “Name” menu, you can enter a freely selectable name for the receiver.
You can, for example, enter the name of the performer for whom the
adjustments have been made.
The name can be displayed on the standard display and can consist of up to
ten characters such as:
y letters (without pronounciation marks),
y numbers from 0 to 9,
y special characters e.g. () - . _ and spaces.
To enter a name, proceed as follows:
̈ Press the SET button to get into the setting mode of the “Name” menu.
The first segment starts flashing on the display.
̈ With the ̆/̄ buttons you can now select a character. By briefly pressing
a button, the display jumps either forwards or backwards to the next
character. If you hold down a button, the display starts cycling
continuously.
̈ Press the SET button to change to the next segment and select the next
character.
̈ Have you entered the name completely? Press the SET button to store
your setting and to return to the top menu level.
Loading the factory-preset default settings
Reset
Via the “Reset” menu, you can load the factory-preset default settings. Only
the selected setting for the pilot tone remains unchanged. After the reset, the
receiver is restarted and the standard display is shown on the display panel.
Activating/deactivating the pilot tone evaluation
Pilot
Via the “Pilot” menu, you can activate or deactivate the pilot tone evaluation.
The pilot tone supports the receiver’s squelch function (Squelch) and protects
against interference due to RF signals from other units. The transmitter adds
an inaudible signal, known as the pilot tone, to the transmitted signal. The
receiver detects and evaluates the pilot tone, and is thus able to identify the
signal of the matching transmitter and mute all others.
Transmitters of the ew 500 series (first generation) do not transmit a pilot
tone and the receivers of the ew 500 series (first generation) cannot
evaluate the pilot tone. Nevertheless, you can combine the EM 500 G2
receiver with a transmitter of the first generation. However, when combining
units, please observe the following:
y With an ew 500 G2 transmitter and the ew 500 G2 receiver:
Activate the pilot tone function with both transmitter and receiver.
y With an ew 500 transmitter and the ew 500 G2 receiver or vice versa:
Deactivate the pilot tone function with the ew 500 G2 transmitter or receiver.