Filter
Top Products
13
Using the receiver
Switching the receiver on/off
The receiver can only be switched off when the standard display is shown on
the display panel. When in the operating menu, briefly pressing the ON
button will cancel your entry (ESC function) and return you to the standard
display with the last stored settings.
̈ Press the ON button ² to switch the receiver on.
̈ To switch the receiver off, press the ON button until “OFF” appears on the
display.
Connecting the headphones/adjusting the volume
̈ To monitor the audio signal, connect headphones with a ¼” (6.3 mm) jack
plug to the headphone output (PHONES) ᕡ.
Attention! High volume!
Even short exposure to high volume levels will damage your hearing!
Set the volume for the connected headphones to the minimum before
putting the headphones on.
̈ First, set the volume control ᕢ to the lowest volume by turning it to the
left as far as possible. Then gradually turn up the volume.
Volume up? – NO!
When people use headphones, they tend to choose a higher volume than
with loudspeakers. Listening at high volume levels for long periods can
lead to permanent hearing defects. Please protect your hearing,
Sennheiser headphones have an excellent sound quality even at low
volumes.
Activating/deactivating the lock mode
The receiver has a lock mode that can be activated or deactivated via the
operating menu (see “Activating/deactivating the lock mode” on page 24).
The lock mode prevents that the receiver is accidentally programmed or
switched off during operation.
ᕦ
³ ·